SR-71 Mach 3 spy plane’s titanium parts made in summer corroded, those made in winter didn’t

Date:

Blackbird Mach 3+ spy plane

The SR-71, unofficially called the “Blackbird,” was a long-range strategic reconnaissance aircraft capable of speeds exceeding Mach 3. It was developed from the Lockheed A-12 and YF-12A.

The Blackbird’s development began in secret in the late 1950s with the A-12 reconnaissance aircraft. The A-12 made its first flight in April 1962 and remained classified until 1976. President Lyndon Johnson publicly revealed the YF-12A interceptor variant on February 29, 1964—more than six months after its maiden flight. The SR-71 itself first flew on December 22, 1964.

During its nearly 24 years of service, the SR-71 remained the world’s fastest and highest-flying operational aircraft. From an altitude of 80,000 feet, it could survey 100,000 square miles of the Earth’s surface in a single hour. On July 28, 1976, an SR-71 established two world records for its class: an absolute speed record of 2,193.167 mph and an absolute altitude record of 85,068.997 feet.

SR-71 Blackbird Mach 3 spy plane’s titanium parts made in summer corroded while those made in winter didn’t. Here’s why.
The #957 under construction You can see the raised canopy. This aircraft crashed at Beale Air Force Base in 1968.

The Blackbird belonged to a class of its own, unlike any aircraft that had come before it. “Everything had to be invented. Everything,” recalled Kelly Johnson, the legendary aircraft designer behind Skunk Works, in an article published on the Lockheed Martin website.

The SR-71 was built at the Skunk Works facility in Burbank, California. The photographs accompanying this post, taken in 1965, show some of the first aircraft during construction, including the initial B models—957 and 956—alongside an A model, 955. My father, Richard “Butch” Sheffield, told me that he watched these aircraft being assembled at the Burbank Skunk Works plant.

SR-71 aircraft built almost entirely of titanium

The aircraft were constructed almost entirely from titanium and other advanced alloys to endure the extreme temperatures produced during sustained high-speed flight. The Blackbirds were designed to cruise continuously at Mach 3 for more than an hour, at altitudes of up to 85,000 feet.

SR-71 Blackbird Mach 3 spy plane’s titanium parts made in summer corroded while those made in winter didn’t. Here’s why.
It was important to put US Air Force on the airplanes just in case they were flown over or near hostile countries if there was no identification on the airplane they would be considered spies and would be shot. The trainer models never left the US. Nevertheless they were marked just in case they had to leave the US.

Blackbird engineers were initially puzzled by the corrosion affecting some of the aircraft’s titanium components but eventually identified the cause: chlorine in the water.

According to Wisconsin Metal Tech, the SR-71’s engineers were among the first people to use titanium extensively in practical applications. The pioneering effort resulted in significant material waste, caused partly by the demands of the work and partly by mistakes. Although the engineers were sometimes unable to explain why certain problems occurred, they carefully documented and cataloged their failures, allowing them to identify patterns and determine their causes.

Spot welded parts made in summer corroded, those made in winter didn’t

The engineers found that spot-welded components produced during the summer were failing prematurely, while those made in winter performed normally. They eventually traced the problem to the Burbank water-treatment plant, which added chlorine to the water used to clean the parts during summer to control algae growth but stopped doing so in winter. Because chlorine reacts with titanium, the team began using distilled water instead.

They also discovered that cadmium-plated tools were leaving minute traces of cadmium on the bolts, triggering galvanic corrosion and causing the fasteners to fail. As a result, all cadmium-plated tools were removed from the workshop.

Check out Born into the Wild Blue Yonder Facebook page for further Blackbird photos and stories.

The book Ohio to Supersonic: Flying the SR-71 Blackbird to the Secret World of the Skunk Works by Colonel Richard “E.” Butch Sheffield and Linda Marie Sheffield is available to order here.

Lockheed photos via Tony Landis and CIA

Till Daisd
Till Daisdhttps://www.aviation-wings.com
Till is an aviation enthusiast and blogger who has been writing since 2013. He began by sharing personal reflections and book reviews and gradually expanded his blog to cover a wide range of aviation topics. Today, his website features informative articles and engaging stories about the world of aviation, making it a valuable resource for both pilots and curious enthusiasts alike.

LEAVE A REPLY

Please enter your comment!
Please enter your name here


Share post:

Popular

More like this
Related

How A-20 and B-25 bombers defeated Japanese Destroyers in the Bismarck Sea

Throughout the first year of the war in the...

Why the SR-71 is easier to detect than the U-2 with modern IRST

U-2 vs. SR-71 Work on a groundbreaking intelligence aircraft was...

Former US Navy F-14 pilot explains how the Tomcat’s wings enter oversweep

The Tomcat During the Cold War, advances in Soviet long-range...

The B-52 Stratofortress that carried the Flashback Nuclear Test Vehicle, bigger than the Tsar Bomba

The Flashback Test Vehicle was larger by far than...